How to Tune a 16-String Lyre Harp (Step by Step)
A 16-string lyre harp is tuned to a C major scale from G3 up to A5. This guide walks you through the tools, the tuning order and the small habits that keep your lyre sounding sweet for longer.
Standard tuning for a 16-string lyre harp
Almost every 16-string lyre harp is tuned to C major: only the "white key" notes, with no sharps or flats. The lowest string is G3, the highest is A5, and middle C (C4) is the fourth string up from the bass. That gives you just over two octaves — plenty for folk songs, lullabies and simple classical melodies.
Most lyres follow the old harp color code: C strings are red and F strings are blue or black. These colored strings are your landmarks. Once you can spot them, you can find any other string in a second.
| String | Note | Number notation | Color |
|---|---|---|---|
| 1 (lowest) | G3 | 5̣ | plain |
| 2 | A3 | 6̣ | plain |
| 3 | B3 | 7̣ | plain |
| 4 | C4 (middle C) | 1 | red |
| 5 | D4 | 2 | plain |
| 6 | E4 | 3 | plain |
| 7 | F4 | 4 | blue/black |
| 8 | G4 | 5 | plain |
| 9 | A4 | 6 | plain |
| 10 | B4 | 7 | plain |
| 11 | C5 | 1̇ | red |
| 12 | D5 | 2̇ | plain |
| 13 | E5 | 3̇ | plain |
| 14 | F5 | 4̇ | blue/black |
| 15 | G5 | 5̇ | plain |
| 16 (highest) | A5 | 6̇ | plain |
What you need to tune a lyre
- A tuning wrench (tuning key). Most lyre harps come with a small T-shaped or L-shaped key that fits the tuning pins. Keep it in the case so it never goes missing.
- A tuner. A clip-on tuner senses vibration through the wood, so it works well in noisy rooms. A tuner app uses your phone's microphone and is perfect in a quiet room.
- A quiet spot where you can hear each string clearly.
Set your tuner to A4 = 440 Hz and use chromatic mode if it has one — it shows the nearest note, so you notice at once when you are on the wrong string.
Three rules before you turn a single pin
- Make small turns. An eighth of a turn can move the pitch a lot, especially on the thin treble strings. Pluck, read the tuner, adjust, repeat.
- Tune up to the note. If a string is sharp, lower it slightly below the target and then bring it back up. Approaching from below helps the string and pin settle so they hold their pitch.
- Check you are on the right string. If the tuner shows a note far below the target — more than about two whole steps — you are probably plucking the wrong string, or your tuner is set for a different instrument. Don't keep tightening; find the right string first. Over-tightening is the most common way to snap a string.
Not sure which way to turn? Give the pin a tiny nudge while the string rings and watch the tuner. If the pitch goes down when you wanted it up, simply turn the other way. The direction depends on how the string was wound, so it can differ between instruments.
Step-by-step: the best tuning order
You can tune from the bass up, or from the middle outward. For beginners we recommend starting at middle C: the first red string is easy to find, and the middle strings are the ones you play most.
- Tune C4, the red string fourth from the bass.
- Work upward one string at a time: D4, E4, F4, G4, A4, B4, C5.
- Go back to the bass side and tune B3, A3, G3.
- Finish the treble: D5, E5, F5, G5, A5.
- Do a second pass over all 16 strings. Raising the tension on one string slightly changes the tension on the whole frame, so the first strings you tuned will have drifted a little.
How accurate is accurate enough?
Aim for within ±3 cents of the target (a cent is one hundredth of a semitone). Differences that small are very hard to hear. On most tuners that simply means the needle sits in the center or the display turns green.
Check your octaves by ear
A tuner gets you close; your ears confirm it. Play pairs of strings an octave apart: G3–G4, A3–A4, C4–C5, D4–D5, F4–F5. A well-tuned octave sounds like one single, fused note. If you hear a slow "wah-wah" wobble (called beating), one of the two strings is slightly off — re-check both with the tuner.
Finally, play a C major chord (C4, E4, G4) and a gentle sweep across all strings from bottom to top. If everything sounds bright and calm, you are ready to play.
New strings stretch: what to expect
A brand-new lyre, or one with freshly replaced strings, will not stay in tune at first. New strings stretch a lot during the first 3–7 days. This is normal and does not mean anything is broken.
- Retune several times a day for the first few days.
- Gently pull each string a little away from the soundboard along its length, then retune. This speeds up the stretching.
- Tune a few cents above the target while strings are new — they will sink back toward the right pitch.
- After about a week, the strings settle and hold their tuning much better.
How often should you tune?
- First week with new strings: daily, often several times a day.
- Normal playing: a quick check before every practice session.
- After changes in the environment: travel, a cold car, heating, air conditioning or direct sunlight all change string tension. Let the lyre adjust to the room for a while, then tune.
- Nylon vs metal strings: nylon strings stretch more and react more to temperature, so nylon-strung lyres usually need tuning a little more often.
Playing in other keys: levers and retuning
Many budget 16-string lyres have no levers, and that is fine — C major covers a huge number of songs. Some better instruments have semitone levers on some or all strings. Flipping a lever raises that string by exactly one half step.
| Key you want | What to change from C major |
|---|---|
| G major | Raise every F to F♯ (levers on all F strings) |
| D major | Raise F and C to F♯ and C♯ |
| A major | Raise F, C and G |
| F major | Retune every B string down to B♭ — levers can only raise a note, not lower it |
No levers? You can still play in G major by retuning both F strings up to F♯ with your tuner, and tuning them back afterward.
Troubleshooting common tuning problems
The string buzzes
- The string may be touching a neighboring string, the frame or a loose string end. Look closely while it vibrates.
- The coils on the tuning pin may be overlapping or loose. Rewinding them neatly often fixes it.
- A long loose string end can rattle against the wood — trim it or tuck it away.
- Old, worn or kinked strings can buzz too. If nothing else helps, replace the string (see how to change lyre strings).
The string won't hold its pitch
- If the string is new, give it a week of regular retuning.
- If the pin itself slips back, press it gently inward while you turn so it seats firmly. If it still slips, have a repair shop look at it.
- Check that the knot or anchor at the bottom of the string hasn't slipped.
- Large temperature or humidity swings will pull any string out of tune; store the lyre away from heaters and windows.
Frequently asked questions
What notes is a 16-string lyre harp tuned to?
Standard tuning is a C major scale from G3 to A5: G3, A3, B3, C4, D4, E4, F4, G4, A4, B4, C5, D5, E5, F5, G5, A5. The red strings are C and the blue or black strings are F.
Why does my new lyre keep going out of tune?
New strings stretch a lot during the first 3–7 days. Retune several times a day, gently stretch the strings and tune slightly sharp. After about a week they hold their pitch much better.
Which way do I turn the tuning pin?
It depends on how the string is wound, so test with a tiny turn while watching your tuner. If the pitch moves the wrong way, turn the other direction. Always make small turns.
Can I play in F major on a 16-string lyre?
Yes, but not with levers, because levers only raise notes. Retune each B string down to B♭ with a tuner, then tune them back to B when you return to C major.